Tail Lights LED compatible for Volkswagen Tiguan 2009 2010 2011 VW Rear Lamps Assembly Driver Passenger Replacement Set

SPECIFICATION * COMPATIBLE VEHICLES : 2009-2011 Volkswagen Tiguan NOTES : Please make sure this item whether fits for your vehicle before you purchase. * Bulbs Type : LED,W16W 12V16W * Exact Fit OEM# : combination lamp on body: L: 5N0945111E , R: 5N0945112E ; combination lamp on liftgate: L: 5N0945107B , R: 5N0945108C * PARTSLINK# : combination lamp on body: L: VW2804114 , R: VW2805114 ; combination lamp on liftgate: L: VW2802107 , R: VW2803107 WHAT YOU GET * Tail lights 1 set (driver + passenger side , bulbs included ) NOTES : Wiring kit , Switch group & Installation manual are NOT Included. HOW TO INSTALL 1. Open the box and inspect the item. Verify what was received was what you ordered and that the item is free from physical damage or defect. 2. Remove the old tail light. First thing you have to do is undo the mounting screws on the outside, if there’s any. You’ll have to open the trunk or any rear door or opening on the vehicle to access the back of the tail light. The wiring harness must be disengaged from the assembly through its back. 3. Once the wiring harness is out, you can now undo the mounting screws or nuts, whatever fastener is used. With no more screws or nuts holding it in place, you can push out the assembly from behind. Check if the tail light assembly you just removed is the same as the new one. 4. See if they have the same components, design, and fasteners to ensure proper fitting. Fix the new assembly into the tail light pocket. Once it’s fitted into place, secure it with the screws or nuts. Tighten them properly. You can now plug in the wiring harness that you removed earlier. 5. Test the new assembly. Switch on the tail lights to see if they work. If not, then some adjustments should be done to the newly installed tail light kit. Put back any cover, trim, or component that was removed to access the tail light assembly. * NOTE : If it is necessary to replace the bulb, lamp body and bulb are not tight enough to produce water mist，or bulb is not fit lamp body oringinally . Professional Installation is highly recommended.

• Meets or Exceeds DOT & SAE Compliance Standards .
• COMPATIBLE VEHICLES - Fit for 09 10 11 Volkswagen Tiguan
• Exact Fit OEM# - combination lamp on body: L: 5N0945111E , R: 5N0945112E ; combination lamp on liftgate: L: 5N0945107B , R: 5N0945108C
• EXCELLENT SEALING - Meet certain waterproof standards . Dust and corrosion resistant make the tail lights perform well , prevent moisture and dust from getting inside housing.
• WHAT YOU GET - Tail lights 1 set (driver + passenger side , bulbs included ) ; Wiring kit ,switch & installation manual are NOT included. 30-day warranty guarantee, 24/ 7 customer service .